Range Rover Evoque: European declaration of conformity

Hereby, DENSO CORPORATION

Hereby, DENSO CORPORATION declares that this DN-NS-019 is in compliance with the essential requirements and other relevant provisions of Directive 1999/5/EC.

READ NEXT:

 Fuel and refuelling

 Safety precautions

Avoid exposing the fuel gasses to any potential sources of ignition as the resulting fire and explosion may cause serious injuries and/or death. Switch off the engine when refuelling, as it is

 Petrol engined vehicles

Do not use leaded fuels, lead substitutes, or fuel additives. Fuel system cleaning agents should not be used, unless approved by Land Rover.

SEE MORE:

  Wipers and Washers - Removal and Installation

Windshield Wiper Motor Removal NOTE: Removal steps in this procedure may contain installation details. 1. Refer to: Plenum Chamber (412-01 Climate Control, Removal and Installation). 2. NOTE: LHD illustration shown, RHD is similar. Torque: 8 Nm Installation 1. To install, reverse the removal proced

  Bumpers

Front Bumper Cover Removal NOTE: Removal steps in this procedure may contain installation details. 1. 2. 3. WARNING: Make sure to support the vehicle with axle stands. Raise and support the vehicle. 4. NOTE: The step must be carried out on both sides. Refer to: Fender Splash Shield (501-02 Front E

© 2011-2026 Copyright www.rrevoque.org - 0.0069