Range Rover Evoque: Flat spots due to long term parking

In order to minimise flat spotting, the tyre pressures can be increased to the maximum as stated on the tyre sidewall, for the period when the vehicle is stationary. Tyres must be returned to the specified running pressures before driving.

READ NEXT:

 Age degradation

Tyres degrade over time due to the effects of ultraviolet light, extreme temperatures, high loads, and environmental conditions. It is recommended that tyres are replaced at least every six years,

 Winter tyres

In many countries legislation exists that requires the use of winter tyres during specified periods of the year. M+S tyres have a recognised level of winter performance and need not be replaced.

 Using traction devices

Only use traction devices in heavy snow conditions, on hard road surfaces. Dynamic Stability Control (DSC) must be switched off when using traction devices. Never exceed 50 km/h (30 mph) when

SEE MORE:

 Condenser GTDi 2.0L Petrol

Removal CAUTION: Make sure that all openings are sealed. Use new blanking caps. NOTES: Some variation in the illustrations may occur, but the essential information is always correct. Removal steps in this procedure may contain installation details. 1. Disconnect the battery ground cable. Refer t

 Seats - System Operation and Component Description

Control Diagram NOTE: A = Hardwired; N = Medium speed CAN (controller area network) bus; O = LIN (local interconnect network) bus CONTROL DIAGRAM - FRONT POWER OPERATED NON-MEMORY SEATS Driver seat forward-rearward motor Driver seat recline motor Driver seat height motor Driver lumbar pump D

© 2011-2026 Copyright www.rrevoque.org