Range Rover Evoque: Grass-gravel-snow

This program should be used

This program should be used where a firm surface is covered with loose or slippery material.

Note: For deep snow it is recommended that the Sand program is selected.

Note: If the vehicle is unable to gain traction in deep snow, switching DSC off may help. DSC should be switched on again, as soon as the difficulty is overcome.

READ NEXT:

 Mud-ruts

This program should be used for crossing terrain that is muddy, rutted, soft or uneven. HDC is automatically selected with this program.

 Sand

This program should be used for terrain which is predominantly soft dry sand or deep gravel. Note: If the vehicle is unable to gain traction in extremely soft, dry sand, switching DSC off may h

 Wading

The maximum advisable wading depth is 500mm (19.7in). If the vehicle remains stationary in water above the door sill level, severe electrical damage may occur. Do not switch off the engine when

SEE MORE:

 Air Bag Supplemental Restraint System (SRS)

Component Location COMPONENT LOCATION SHEET 1 OF 2 Battery ECM (engine control module) CJB (central junction box) Passenger air bag Overhead console RCM (restraints control module) Driver air bag Driver lower air bag Clockspring Adaptive steering column BJB (battery junction box) COMPO

 Rear Lamp Mounting Panel

Removal NOTES: The rear lamp mounting panel is manufactured from mild steel. The section of the rear lamp mounting panel described within this procedure is for the access for installation of the inner back panel assembly. The upper NVH component must be replaced when a complete panel is installed

© 2011-2025 Copyright www.rrevoque.org