Range Rover Evoque: Anti-Lock Control - Stability Assist

Accelerometer

Removal

NOTES:

Removal steps in this procedure may contain installation details.

LHD illustration shown, RHD is similar.

Vehicles with automatic transmission

1. Refer to: Floor Console Upper Section (501-12 Instrument Panel and Console, Removal and Installation).

2. Torque: 9 Nm

Range Rover Evoque. Anti-Lock Control - Stability Assist

Vehicles with manual transmission

3. Refer to: Floor Console (501-12 Instrument Panel and Console, Removal and Installation).

4.

Range Rover Evoque. Anti-Lock Control - Stability Assist

5.

Range Rover Evoque. Anti-Lock Control - Stability Assist

6. Torque: 9 Nm

Range Rover Evoque. Anti-Lock Control - Stability Assist

Installation

1. To install, reverse the removal procedure.

2. If a new component has been installed, configure using Land Rover approved diagnostic equipment.

READ NEXT:

 Steering System

 Power Steering

 Power Steering AWD

Component Location Steering gear Rubber seal assembly Heat shield Overview The vehicle is fitted with EPS (electric power steering), provided by a ZF Servolectric steering gear unit with variab

SEE MORE:

 Engine System - General Information

Cylinder Head Gasket Selection TD4 2.2L Diesel Special Tool(s) 303-979 Measuring Bridge, Piston Protusion 1. CAUTION: Make sure that the surface is clean and free of foreign material. Zero the gauge on the cylinder block machined face. Special Tool(s): 303-979 2. CAUTION: Make sure that the surfac

 Stoplamps

Principle of Operation For information on the description and operation of the system, refer to relevant section of the workshop manual. REFER to: (417-01 Exterior Lighting) Note that the stoplamps will be activated automatically under certain conditions when the ride and handling optimization fun

© 2011-2025 Copyright www.rrevoque.org