Range Rover Evoque: Accessing navigation
From the Home menu touch the On road nav soft key. Alternatively press the NAV hard key on the facia. A caution screen will be displayed.
If the navigation screen language has not been set, now is the time to set it. Select Language, make a selection and confirm it by touching the OK soft key. You will be returned to the CAUTION screen.
After touching the Agree soft key, the touch screen will display the MENU or the screen that was in use when you last switched off the system.
Note: After approximately 12 seconds, the menu soft keys will disappear and display the map information only. This will show current vehicle position. Touch the Nav menu soft key to display the full MENU screen.
At this point, the first time user should set up personal preferences in the Nav setup area.
These settings are applied whenever navigation is used.
READ NEXT:
Vehicle position error
Under certain conditions it is possible for the
vehicle position shown on screen to be
incorrect. This may happen when:
- Driving on a spiral ramp in a building.
- Driving on or beneath elevated r
Navigation controls
Consists of two menu screens. Icons for the second menu are shown
individually.
Navigation controls
See 104, TOUCH SCREEN OVERVIEW.
1. Move to other Navigation menu.
2. Cancels current route g
Map split screen
Map split screen
1. TMC (Traffic Message Channel)
information.
2. North is up.
3. Small compass display which always
indicates North.
4. Next direction display.
5. Current vehicle position.
SEE MORE:
Hydraulic Brake Actuation
Hydraulic Brake Actuation LHD AWD/RHD AWD - Component Location
NOTE: RHD (right-hand drive) installation shown, LHD (left-hand drive)
installation similar.
COMPONENT LOCATION
Brake pedal
Hydraulic pipes
Integrated HCU (hydraulic control unit) and ABS (anti-lock brake system)
module
Brake ma
Keyless start backup
If the vehicle has been unlocked using the
emergency key blade or the Smart Key is not
detected by the vehicle, it will be necessary to
use the keyless start backup to disarm the
alarm and start the engine.
The keyless start backup can only be used
when the message Smart Key Not Found Refer
t
