Range Rover Evoque: Block Heater
Removal
1. Refer to: Cooling System Partial Draining, Filling and Bleeding (303-03B Engine Cooling - GTDi 2.0L Petrol, General Procedures).
2. Refer to: Engine Undershield (501-02 Front End Body Panels, Removal and Installation).
3. Refer to: Front Bumper Cover (501-19 Bumpers, Removal and Installation).
4. NOTE: Measure and mark a 70mm section of the pipe using the clamp as a guide.
5. NOTE: Discard the bolt and clamp.
Installation
1. Torque: 20 Nm
2. Torque: 6 Nm
3. NOTE: Using a suitable tool, cut a 70mm gap from the coolant pipe.
4. Torque: 3 Nm
5. CAUTION: Protect the surrounding paintwork and body from the movement of the cutting blades.
NOTE: Following the indent on the bumper and using a suitable tool, cut a 26mm hole in the front bumper cover.
6.
7. Refer to: Front Bumper Cover (501-19 Bumpers, Removal and Installation).
8. CAUTION: Make sure the retaining clip is secured correctly.
9.
10. NOTE: Make sure all ground connections are correctly installed. Torque: 10 Nm
11. Fill the engine coolant and test the block heater for correct operation.
Refer to: Cooling System Partial Draining, Filling and Bleeding (303-03B Engine Cooling - GTDi 2.0L Petrol, General Procedures).
12. Refer to: Engine Undershield (501-02 Front End Body Panels, Removal and Installation).
READ NEXT:
Fuel Charging and Controls - Component Location, System Operation and Component Description
Component Location
COMPONENT LOCATION
Overview
OVERVIEW
The 2.0L GTDi engine is equipped with a high-pressure direct injection system
controlled by the ECM (engine control
module). A high-pressure f
Throttle Body
Removal
NOTES:
Removal steps in this procedure may contain installation details.
Some illustrations may show the engine removed for clarity.
1. WARNING: Make sure to support the vehicle with axle sta
SEE MORE:
Transmission Draining and Filling
WARNING: Observe due care when draining, as the fluid can be very hot.
1. WARNING: Make sure to support the vehicle with axle stands.
NOTE: Make sure that the vehicle is standing on a level
surface.
Raise and support the vehicle.
2. Refer to: Engine Undershield (501-02 Front End Body Panels,
Remo
Using the repair kit
Avoid skin contact with the
sealant
which contains natural rubber latex.
Do not unscrew the sealant bottle from
the receiver until it is empty, as
sealant will leak out.
If the tyre inflation pressure does not
reach 1.8 bar (26 lb/in²) within seven
minutes, the tyre may have suffered
