Range Rover Evoque: Commandshift™

To return to Sport mode after CommandShift has been selected, move the selector back to D then back to Sport mode. Transmission Commandshift Selected will appear in the message centre when the transmission is in CommandShift mode.

Note: In order to protect the engine, the transmission will automatically change up to prevent over-revving, or down if the engine is labouring.

READ NEXT:

 Kick-down

Push the accelerator pedal fully down to achieve rapid acceleration in automatic mode. When the pedal is relaxed, normal gear changing will resume.

 Drive selector

P should normally be selected before switching off the engine. If any other gear is selected at turn off, the selector will move to P before retracting into the centre console. If the engine is sw

 Drive selector fails to elevate

If the drive selector is obstructed, remove the obstruction and then start the engine. The selector should elevate as normal. If the selector still fails to elevate, even if there is no obstructio

SEE MORE:

 Topping up the washer fluid

The washer reservoir supplies the front and rear screen washer jets and headlamp washer jets. Check and top-up the reservoir level at least every week. Always top-up with screen washer fluid to prevent freezing. Operate the washer switches periodically to check that the nozzles are clear and

 A-Pillar Outer Panel

Removal NOTES: The A-pillar outer panel is manufactured from mild steel. The fender mounting bracket is serviced on the new panel. The upper and lower butt joint must be MIG brazed due to the location of a boron reinforcement. A new anti tamper VIN indentification decal will be required when rep

© 2011-2026 Copyright www.rrevoque.org