Range Rover Evoque manuals

Range Rover Evoque: Conditions preventing automatic engine stop

Land Rover Range Rover Evoque L538 (2011–2018) Owner's Manual / Starting the engine / Conditions preventing automatic engine stop

The engine will not automatically stop if:<>
- the external temperature is below approximately 0°C (32°F)
- the external temperature is above approximately40°C (104°F)
- engine has not reached operating temperature
- driver’s seat belt is not fastened
- driver’s door is not fully closed
- the driver’s foot is on either the clutch or accelerator pedals
- climate control system demand is high
- battery charge is low
- the DPF is regenerating
- HDC or a Terrain Response special program are selected

Note: The stop/start system is disabled when a trailer electrical connection is made.

READ NEXT:

 Conditions causing automatic engine restart

The engine will automatically start if:<> - climate control system demand increases - the vehicle’s speed reaches approximately 4km/h (2.5mph) - HDC or a Terrain Response special program ar

 Disabling stop/start

Disabling stop/start To switch the system off (preventing automatic stop/start) press the ECO switch. The LED indicator will extinguish to confirm that the system is off. Note: The engine will

 Eco stall recovery

In the event that the engine stalls, it can be restarted by fully depressing the clutch pedal. Note: Automatic stall restart will only operate once. If the engine is stalled a second time the engi

SEE MORE:

 Vehicle information and settings menu

Vehicle information and settings menu A number of vehicle features and display settings may be configured via the vehicle information and settings menu. To display and navigate through the vehicle information and settings menu, operate the menu control on the steering wheel. 1. Steering whe

 Transmission GTDi 2.0L Petrol - Installation

Installation NOTE: Some variation in the illustrations may occur, but the essential information is always correct. 1. NOTE: This step is only required if previously removed. Torque: 12 Nm 2. NOTE: This step is only required if previously removed. 3. CAUTION: Make sure that the seal is correctly

© 2011-2026 Copyright www.rrevoque.org