Range Rover Evoque: Driver Seat Cushion Vehicles With: Sports Seats
Removal
NOTE: Removal steps in this procedure may contain installation details.
All vehicles
1. Disconnect the battery ground cable.
Refer to: Specifications (414-01 Battery, Mounting and Cables, Specifications).
2. Make the SRS system safe.
Refer to: Standard Workshop Practices (100-00 General Information, Description and Operation).
3. Refer to: Front Seat Cushion Cover - Vehicles With: Sports Seats (501-10 Seating, Removal and Installation).
Vehicles with heated front seats
4. NOTE: Some variation in the illustrations may occur, but the essential information is always correct.
5.
Installation
1. To install, reverse the removal procedure.
Driver Seat Cushion Heater Mat Vehicles With: Sports Seats
Removal
NOTE: Removal steps in this procedure may contain installation details.
1. Disconnect the battery ground cable.
Refer to: Specifications (414-01 Battery, Mounting and Cables, Specifications).
2. Make the SRS system safe.
Refer to: Standard Workshop Practices (100-00 General Information, Description and Operation).
3. Refer to: Front Seat Cushion Cover - Vehicles With: Sports Seats (501-10 Seating, Removal and Installation).
4. NOTE: Some variation in the illustrations may occur, but the essential information is always correct.
5.
Installation
1. To install, reverse the removal procedure.
READ NEXT:
Passenger Seat Cushion Vehicles With: Sports Seats
Removal
NOTE: Removal steps in this procedure may contain installation details.
All vehicles
1. Disconnect the battery ground cable.
Refer to: Specifications (414-01 Battery, Mounting and Cables,
Spe
Glass, Frames and Mechanisms - Component Location, System
Operation and Component Description
Component Location
COMPONENT LOCATION - DOOR MECHANISMS
Passenger door glass motor
Passenger door module
Rear door glass motor
Rear door module
Rear fuse box
Rear door glass motor
Rear door m
SEE MORE:
Catalyst Monitor Sensor
Special Tool(s)
310-121
Wrench, H02S
Removal
WARNING: Observe due care when working near a hot exhaust system.
NOTE: Removal steps in this procedure may contain installation details.
1. WARNING: Make sure to support the vehicle with axle stands.
Raise and support the vehicle.
2. Disconnect the batt
Fuse box locations
Fuse box locations
When a fuse box lid is
removed, take
care to protect the box from moisture,
and refit the lid at the earliest
opportunity.
Engine compartment - fuse box access:
1. Remove the two plastic fixings.
2. Pull the tube up to release from the air box.
3. Delatch the tabs. Th
