Range Rover Evoque: Dynamic stability control (DSC)

DSC is automatically enabled each time the engine is started, and is automatically enabled by some of the Terrain response special programs.

for The vehicle is not designed for cornering at the same speed as conventional passenger cars any more than a low-slung sports car is designed to perform satisfactorily under off-road conditions. If at all possible, avoid sharp turns or abrupt manoeuvres. As with other vehicles of this type, failure to operate the vehicle correctly may result in loss of control or vehicle rollover.

READ NEXT:

 Dsc warning lamp

The amber DSC warning lamp in the instrument panel illuminates briefly when the ignition is switched on and extinguishes when the engine is started. If the lamp flashes while driving, the DSC

 Disabling dsc

Safety may be reduced by inappropriately disabling DSC. In the majority of driving situations, and particularly on-road, it is recommended that you do not disable DSC. In some driving condition

 Re-enabling dsc

DSC is re-enabled by one of the following: - Press and briefly hold the DSC OFF switch. - Stop and restart the engine. - Select a new Terrain Response special program.

SEE MORE:

 Active On-Demand Coupling Vehicles With: M66 6-Speed Manual Transmission AWD

Removal 1. WARNING: Make sure to support the vehicle with axle stands. Raise the vehicle on a lift. 2. Remove the exhaust system. Refer to: Exhaust System (309-00B Exhaust System - TD4 2.2L Diesel, Removal and Installation). 3. CAUTION: Make sure that the driveshaft is supported with suitable retai

 A-Pillar Trim Panel, B-Pillar Upper Trim Panel 5-Door

A-Pillar Trim Panel Removal NOTE: Removal steps in this procedure may contain installation details. 1. Torque: 6 Nm Installation 1. To install, reverse the removal procedure. B-Pillar Upper Trim Panel 5-Door Removal NOTE: Removal steps in this procedure may contain installation details. 1. 2. 3.

© 2011-2025 Copyright www.rrevoque.org