Range Rover Evoque manuals

Range Rover Evoque: Engine compartment overview

Land Rover Range Rover Evoque L538 (2011–2018) Owner's Manual / Fluid level checks / Engine compartment overview

Engine compartment overview
Engine compartment overview

2.0L petrol engine

1. Brake/clutch fluid reservoir caps (beneath covers): A. Left-hand drive vehicles.

B. Right-hand drive vehicles.

2. Engine oil filler cap.

5. Oil level dipstick.

6. Washer fluid filler cap.

7. Engine coolant filler cap.

possibility Do not drive if there is a possibility that leaked fluid will come into contact with a hot surface, such as the exhaust.

2.2L Diesel engine

1. Brake/clutch fluid reservoir cap (beneath covers): A. Left-hand drive vehicles.

B. Right-hand drive vehicles.

3. Engine oil filler cap.

4. Oil level dipstick.

6. Washer fluid filler cap.

7. Engine coolant filler cap.

READ NEXT:

 Engine oil check

Check the engine oil weekly. If any significant or sudden drop in oil level is noted, seek qualified assistance. Never allow the oil level to fall below the lower mark or notch on the dipstick.

 Oil check preparation

Prior to checking the oil level ensure that: - The vehicle is on level ground. - The engine oil is cold. Note: If it is necessary to check the oil level when the engine is hot, switch off the engi

 Topping up the engine oil

Your vehicle warranty may be invalidated if damage is caused by using oil that does not meet the required specification. Failure to use an oil that meets the required specification could cause

SEE MORE:

 Foot brakes

Do not rest your foot on the brake pedal while the vehicle is in motion. Never allow the vehicle to coast (freewheel) with the engine turned off. The engine must be running to provide full braking assistance. The brakes will still function with the engine off, but far more pressure will be

 Suspension Top Mount

Removal NOTES: The suspension top mount is manufactured from mild steel and RP220. The service panel is serviced not fully spot welded. The panel is serviced less its weld studs 1. In this procedure, to make sure the vehicle is correctly aligned, it must be placed on an approved alignment jig. 2.

© 2011-2025 Copyright www.rrevoque.org