Range Rover Evoque manuals

Range Rover Evoque: Engine starting

Land Rover Range Rover Evoque L538 (2011–2018) Owner's Manual / Starting the engine / Engine starting

leave it Never start the engine, or leave it running, when the vehicle is in an enclosed space. Exhaust gasses are poisonous and can cause unconsciousness and death if inhaled.

do not If the engine fails to start, do not continue cranking as this will discharge the battery. It may also damage the catalytic convertor due to unburnt fuel passing through the exhaust.

Note: For diesel engined vehicles the delay period before cranking begins will be longer in low ambient temperatures due to extended glow plug operation. During this extended delay the clutch pedal (manual transmissions) or brake pedal (automatic transmissions) must remain depressed.

The diesel engine glow plug

The diesel engine glow plug warning lamp will remain illuminated while the glow plugs are operating.

READ NEXT:

 Engine starting: automatic transmission

1. A valid Smart Key must be inside the vehicle. 2. Make sure the gear selector is in P or N. 3. Firmly depress the brake pedal. 4. Press and release the start button. The engine will crank autom

 Engine starting: manual transmission

Note: Do not press the accelerator pedal when starting the engine. 1. A valid Smart Key must be inside the vehicle. 2. Fully depress the clutch pedal. 3. Press and release the start button. For

 If the engine fails to start

Note: If the engine fails to crank when the START/STOP button is pressed and there has been a recent collision, seek qualified assistance. If the engine fails to crank, or fails to start, consult

SEE MORE:

 Transfer Case Rear Seal

Special Tool(s) 100-012 Slide Hammer 205-871 Installer, Transfer Case Rear Seal 308-615 Remover, Seals 308-617 Depth Drill, Seal Remover Removal NOTES: Removal steps in this procedure may contain installation details. Some variation in the illustrations may occur, but the essential information is

 Rear Wheelhouse Outer

Removal NOTES: It is necessary to remove the inner quarter panel to enable removal and installation of the rear wheelhouse outer. The rear wheelhouse outer is manufactured from mild steel. This method describes the LH rear wheelhouse outer, the RH side is similar. 1. The rear wheelhouse outer is

© 2011-2025 Copyright www.rrevoque.org