Range Rover Evoque: Evaporator Temperature Sensor
Removal
NOTE: Removal steps in this procedure may contain installation details.
1. Disconnect the battery ground cable.
Refer to: Specifications (414-01 Battery, Mounting and Cables, Specifications).
2. Refer to: Floor Console Upper Section (501-12 Instrument Panel and Console, Removal and Installation).
3.
4.
5.
6.
Installation
1. To install, reverse the removal procedure.
Heater Core TD4 2.2L Diesel
Removal
NOTE: Removal steps in this procedure may contain installation details.
1. Disconnect the battery ground cable.
Refer to: Specifications (414-01 Battery, Mounting and Cables, Specifications).
2. Refer to: Cooling System Partial Draining, Filling and Bleeding (303-03A Engine Cooling - TD4 2.2L Diesel, General Procedures).
3. Refer to: Electric Booster Heater (412-02 Auxiliary Climate Control, Removal and Installation).
4. CAUTION: Be prepared to collect escaping coolant.
5.
6. CAUTION: Be prepared to collect escaping coolant.
Installation
1. To install, reverse the removal procedure.
READ NEXT:
Condenser TD4 2.2L Diesel
Removal
CAUTION: Make sure that all openings are sealed. Use new blanking caps.
NOTES:
Removal steps in this procedure may contain installation details.
Some variation in the illustrations may occur
Heater Core and Evaporator Core Housing
Removal
NOTE: Removal steps in this procedure may contain installation details.
1. Make the SRS system safe.
Refer to: Standard Workshop Practices (100-00 General Information,
Description and Operati
Defrost Vent/Register Blend Door Actuator LHD AWD/LHD
FWD
Removal
NOTE: Removal steps in this procedure may contain installation details.
1. Disconnect the battery ground cable.
Refer to: Specifications (414-01 Battery, Mounting and Cables,
Specifications).
SEE MORE:
Rear Side Member Lower Side Extension
Removal
NOTE: The rear side member lower side extension is manufactured from mild
steel.
1. The rear side member lower side extension is replaced in
conjunction with:
Rear bumper cover
Rear bumper
Rear lamp mounting panel
2. For additional information relating to this repair procedure please
Inner Quarter Panel
Removal
NOTES:
The inner quarter panel is manufactured from mild steel.
There are NVH components on this panel, they are not serviced on the new panel.
If damaged, new components will be required.
1. The front inner quarter panel is replaced in conjunction with:
Rear bumper cover
Quarter panel
