Range Rover Evoque: Foot brakes
Do not rest your foot on the
brake
pedal while the vehicle is in motion.
Never allow the vehicle to coast
(freewheel) with the engine turned off.
The engine must be running to provide
full braking assistance. The brakes
will still function with the engine off,
but far more pressure will be required
to operate them.
If the red brake warning indicator
illuminates, safely bring the vehicle to
a stop, as quickly as possible and
seek qualified assistance.
Never place non-approved floor
matting or any other obstructions
under the brake pedal. This restricts
pedal travel and braking efficiency.
Driving through heavy rain or water can have an adverse effect on braking efficiency. Under such circumstances, it is recommended that you lightly apply the brakes intermittently, to dry the brakes.
READ NEXT:
Abs warning lamp
The ABS warning lamp illuminates
briefly when the ignition is turned
on.
If this amber warning lamp illuminates when
driving (accompanied by an associated
warning message), drive with extra caut
Steep slopes
If the vehicle is stationary on a steep, slippery
slope, it may begin to slide even with the
brakes applied. This is because without wheel
rotation, the ABS cannot determine vehicle
movement.
To
Emergency brake assist (EBA)
If the driver rapidly applies the brakes, EBA
automatically boosts the braking force to its
maximum, in order to bring the vehicle to a halt
as quickly as possible. If the driver applies the
brake
SEE MORE:
Seat belt (red)
Seat belt (red)
Illuminates when the ignition is on
and an occupied front seat belt is
unbuckled. The lamp will
extinguish after sixty seconds or when the
relevant seat belt(s) is buckled. In some
markets a warning chime will sound while the
lamp is illuminated.
Note: In some markets, the
Shock Absorber and Spring Assembly Vehicles Without:
Dynamic Suspension
Special Tool(s)
205-754A
Splitter, Ball Joints
205-857
Remover, Halfshaft
JLR-204-804
Lever, Wheel Knuckle
General Equipment
Transmission jack
Wooden Block
Removal
CAUTION: Nuts and bolts must be tightened with the weight of the vehicle
on the suspension.
NOTE: Some variation in the illustrati
