Range Rover Evoque: Fuel Filter
Special Tool(s)
310-123
Locking Ring, Fuel Tank
Removal
WARNINGS:
Wait for a minimum of 1 minute after the engine has stopped before carrying out any repair to the fuel injection system.
Avoid flames, sparks or lighted substances.
CAUTION: Be prepared to collect escaping fuel.
NOTE: Removal steps in this procedure may contain installation details.
1. WARNING: Make sure to support the vehicle with axle stands. Raise and support the vehicle.
2. Disconnect the battery ground cable.
Refer to: Specifications (414-01 Battery, Mounting and Cables, Specifications).
3. Refer to: Fuel Tank (310-01B Fuel Tank and Lines - GTDi 2.0L Petrol, Removal and Installation).
4.
5. CAUTIONS: Extreme cleanliness must be exercised when handling these components.
Make sure that the seal is correctly positioned.
Failure to follow this instruction may result in damage to the vehicle.
NOTE: Some variation in the illustrations may occur, but the essential information is always correct.
- Special Tool(s): 310-123
- Torque: 200 Nm
6.
Installation
1. To install, reverse the removal procedure.
Fuel Level Sender
Removal
NOTE: Removal steps in this procedure may contain installation details.
1. WARNING: Make sure to support the vehicle with axle stands. Raise and support the vehicle.
2. Disconnect the battery ground cable.
Refer to: Specifications (414-01 Battery, Mounting and Cables, Specifications).
3. Refer to: Fuel Pump and Sender Unit (310-01B Fuel Tank and Lines - GTDi 2.0L Petrol, Removal and Installation).
4.
5. NOTE: Do not disassemble further if the component is removed for access only.
Installation
1. To install, reverse the removal procedure.
Fuel Pump and Sender Unit
Removal
NOTE: Removal steps in this procedure may contain installation details.
1. WARNING: Make sure to support the vehicle with axle stands. Raise and support the vehicle.
2. Disconnect the battery ground cable.
Refer to: Specifications (414-01 Battery, Mounting and Cables, Specifications).
3. Refer to: Fuel Filter (310-01B Fuel Tank and Lines - GTDi 2.0L Petrol, Removal and Installation).
4.
Installation
1. To install, reverse the removal procedure.
READ NEXT:
Fuel Tank
Special Tool(s)
310-123
Locking Ring, Fuel Tank
Removal
WARNINGS:
Fuel may still be present in the fuel tank after draining.
Avoid flames, sparks or lighted substances.
CAUTIONS:
Extreme cleanliness
Fuel Tank and Lines - Diagnosis and Testing
Principles of Operation
For a detailed description of the fuel tank and lines systems, refer to the
relevant Description and Operation section in the
workshop manual. REFER to: (310-01B Fuel Tank and
Speed Control
Speed Control Actuator
Removal
1. Refer to: Accelerator Pedal (310-02 Acceleration Control, Removal
and Installation).
Installation
1. To install, reverse the removal procedure.
Speed Control Deactiv
SEE MORE:
Evaporator LHD
Removal
NOTES:
The removal of this component involves cutting an aperture in the evaporator
housing wall and cutting through the
high and low pressure A/C lines. A service repair kit is supplied to cover this
procedure.
Removal steps in this procedure may contain installation details.
1. Disconne
Wheel changing
WARNING - THAT NO PERSON
SHOULD PLACE ANY PORTION OF
THEIR BODY UNDER A VEHICLE THAT
IS SUPPORTED BY A JACK.
Position the jack from the side of the
vehicle, in line with the appropriate
jacking point.
Jack up the vehicle using
only the
jacking points described, or damage to
the vehicle
