Range Rover Evoque: Grass-gravel-snow

This program should be used

This program should be used where a firm surface is covered with loose or slippery material.

Note: For deep snow it is recommended that the Sand program is selected.

Note: If the vehicle is unable to gain traction in deep snow, switching DSC off may help. DSC should be switched on again, as soon as the difficulty is overcome.

READ NEXT:

 Mud-ruts

This program should be used for crossing terrain that is muddy, rutted, soft or uneven. HDC is automatically selected with this program.

 Sand

This program should be used for terrain which is predominantly soft dry sand or deep gravel. Note: If the vehicle is unable to gain traction in extremely soft, dry sand, switching DSC off may h

 Wading

The maximum advisable wading depth is 500mm (19.7in). If the vehicle remains stationary in water above the door sill level, severe electrical damage may occur. Do not switch off the engine when

SEE MORE:

 Rear Lamp Mounting Panel

Removal NOTES: The rear lamp mounting panel is manufactured from mild steel. The section of the rear lamp mounting panel described within this procedure is for the access for installation of the inner back panel assembly. The upper NVH component must be replaced when a complete panel is installed

 Headlamp Adjustment

NOTE: The headlamp setting is 1.2 % below horizontal and parallel. 1. Align the headlamp beam setting equipment to one headlamp. 2. Switch the headlamps on and to dipped beam. 3. NOTE: NAS vehicles have vertical adjustment only. Adjust the headlamps with an Allen Key. Rotate the adjuster 'A' for

© 2011-2026 Copyright www.rrevoque.org