Range Rover Evoque: Identification Codes
VIN Number
NOTES:
Some variation in the illustrations may occur, but the essential
information is always correct.
The body VIN is located behind the spare wheel well under the rear carpet.
Windscreen VIN - UK, Europe and ROW

Windscreen VIN - China only

VIN label - UK, Europe and ROW

- Type/Approval Number - If shown
- VIN Number
- Gross Vehicle Weight
- Gross Trailer Weight
- Front Axle Weight
- Rear Axle Weight
- Colour Code Group
VIN label - China

- Vehicle VIN Number
- Engine Type/Capacity/Power
- Occupancy
- Build Date
- Gross Vehicle Weight
- Gross Trailer Weight
VIN label - Gulf markets

- Build Date
- Model year
- Vehicle VIN Number
Tire Data Label - UK, Europe and ROW

- Tire Size
- Tire Pressures
Certification/Tire data label - NAS only

- Vehicle VIN Number
- Bar Code Identification
- Tire Pressures
Tire pressure label - Canada only

- Tire Pressures
- Vehicle VIN Number
- Vehicle Type
VIN number identification
VIN number - UK, EU and ROW



VIN number - NAS and Canada


2.2 Liter Diesel Engine Serial Number

The 2.2 Liter Diesel Engine Serial Number is stamped on the RH side of the
cylinder block.
2.0 Liter Petrol Engine Serial Number

The 2.0 Liter Petrol Engine Serial Number is etched into the RH side of the
engine block.
Automatic Transmission Serial Number

The Automatic Transmission Serial Number is stamped on the LH side of the
transmission casing.
Manual Transmission Serial Number

The Manual Transmission Serial Number is stamped on the transmission casing.
Rear Differential Serial Number

The Rear Differential Serial Number is stamped on the side of the
differential casing.
Power transfer unit

The number is stamped on the underside of the casing.
READ NEXT:
General
WARNING: The
following instructions must be adhered to before raising the vehicle off the
ground:
Position vehicle on a solid, level surface.
Apply the parking brake.
Select 'P' - PARK
Two-Post Lift
WARNING:
Make sure that the vehicle is stable before commencing work.
CAUTION: If
the drive shaft(s) are to be removed, release the parking brake and select
NEUTRAL 'N' in the
trans
SEE MORE:
To start the vehicle using a starting aid or a
slave battery, follow the instructions in the
sequence given.
1. Connect the positive (Red) booster cable to
the positive (+) battery terminal of the
discharged battery.
2. Connect the negative (Black) booster cable
to the vehicle earth point.
3
General Specification
Torque Specifications
* New nuts/bolts must be installed
Brake Pads
Removal
WARNING: Brake pads must be renewed in axle sets only. Failure to follow
this instruction may result in braking
efficiency being impaired.
CAUTION: LH illustration shown, RH is similar.
1. Connect th
© 2011-2026 Copyright www.rrevoque.org
