Range Rover Evoque: Oil Cooler
Removal
NOTE: Removal steps in this procedure may contain installation details.
1. WARNING: Make sure to support the vehicle with axle stands.
Raise and support the vehicle.
2. Disconnect the battery ground cable.
Refer to: Specifications (414-01 Battery, Mounting and Cables,
Specifications).
3. Refer to: Cooling System Partial Draining, Filling and Bleeding
(303-03B Engine Cooling - GTDi 2.0L Petrol, General Procedures).
4. Refer to: Engine Oil Draining and Filling (303-01B Engine - GTDi 2.0L
Petrol, General Procedures).
5. Refer to: Engine Cover - GTDi 2 0L Petrol (501-05 Interior Trim and
Ornamentation, Removal and Installation).
6.

7. CAUTION: Make sure that the area around the
component is clean and free of foreign material.
READ NEXT:
Removal
NOTES:
Some illustrations may show the engine removed for clarity.
Some variation in the illustrations may occur, but the essential information is
always correct.
Removal steps in this proc
Removal
NOTES:
Some illustrations may show the engine removed for clarity.
Some variation in the illustrations may occur, but the essential information is
always correct.
Removal steps in this proc
Removal
NOTES:
Some illustrations may show the engine removed for clarity.
Some variation in the illustrations may occur, but the essential information is
always correct.
1. Refer to: Specifications
SEE MORE:
The rotary drive selector rotates in either
direction. At engine start up, the selector
elevates out of its parked position.
1. To select D (Drive) or R (Reverse) gear,
apply the foot brake then rotate the drive
selector. The related LED by the selector
will illuminate.
Note: If pressure is
When a problem is detected, the warning lamp
will illuminate or flash. A text message will be
displayed. Until the fault is rectified, the
warnings will be repeated each time the
ignition is switched on.
Driving through variable climatic conditions
can affect tyre pressures. This in turn may
© 2011-2025 Copyright www.rrevoque.org
