Range Rover Evoque: Power Liftgate Switch, Liftgate
Power Liftgate Switch
Removal
NOTE: Removal steps in this procedure may contain installation details.
1.
2. Torque: 4 Nm
3. Torque: 4 Nm
4.
Installation
1. To install, reverse the removal procedure.
Liftgate
Removal
CAUTION: The headliner must be lowered as a complete unit to gain access to the electrical connections. Partial lowering of the headliner may cause damage.
NOTE: Removal steps in this procedure may contain installation details.
1. Refer to: Rear Spoiler (501-08 Exterior Trim and Ornamentation, Removal and Installation).
2.
3.
4.
5. Support the liftgate in the open position.
6. CAUTIONS:
Use a suitable sharp pointed hook, release the retaining clip (do not fully remove the clip).
Protect the surrounding paintwork to avoid damage.
Protect the surrounding components.
NOTES:
The step must be carried out on both sides.
Note the orientation of the clip.
7. CAUTIONS:
Take extra care not to damage the wiring harnesses.
Make sure the tailgate harnesses are withdrawn through the body harness apertures when removing the tailgate.
NOTES:
This step requires the aid of another technician.
Note the position of the wiring harnesses to aid installation.
8. NOTE: Do not disassemble further if the component is removed for access only.
Refer to: Liftgate Window Glass (501-11 Glass, Frames and Mechanisms, Removal and Installation).
9. NOTE: The step must be carried out on both sides.
10. CAUTIONS:
Use a suitable sharp pointed hook, release the retaining clip (do not fully remove the clip).
Protect the surrounding paintwork to avoid damage.
Protect the surrounding components.
NOTES:
The step must be carried out on both sides.
Note the orientation of the clip.
11. Refer to: Liftgate Latch (501-14 Handles, Locks, Latches and Entry Systems, Removal and Installation).
12. Torque: 5 Nm
13.
14.
15.
16. Refer to: Rear Window Wiper Motor (501-16 Wipers and Washers, Removal and Installation).
Installation
1. NOTE: Make sure that the clips are installed in the correct orientation.
To install, reverse the removal procedure.
2. Check the liftgate alignment.
Refer to: Liftgate Alignment (501-03 Body Closures, General Procedures).
READ NEXT:
Rear Door
Removal
NOTES:
Removal steps in this procedure may contain installation details.
Some variation in the illustrations may occur, but the essential information is
always correct.
1. Disconnect the bat
Fuel Filler Door
Removal
CAUTION: Make sure to protect the paintwork.
1.
Installation
1.
Fuel Filler Door Assembly
Removal
WARNING: Avoid flames, sparks or lighted substances.
CAUTION: Extreme cleanliness must be ex
Body Closures - Component Location, System Operation and Component
Description
Component Location
Powered Tailgate - Component Location
Tailgate module
Powered strut
Tailgate open button
Tailgate close button
Latch assembly
Powered cinch motor
Powered strut
OVERVIEW
Ta
SEE MORE:
Starting a disabled vehicle using booster cables
Rotating parts of the engine
can cause
serious injury. Take extreme care
when working near rotating parts of
the engine.
Before attempting to start the disabled
vehicle, make sure that the parking
brake is applied, or suitably chock the
wheels. Make sure that Park is
selected or the manua
Component Description
Parking Aid Module
The parking aid module is located on the LH side of the luggage compartment,
behind the 'C' pillar trim panel.
The parking aid module has three connectors which provide for power, ground and
CAN bus connections, front parking aid
sensors and rear parking aid sensors.
The high
