Range Rover Evoque: Replacement tyres

Do not fit tubed tyres. Do not fit cross ply tyres.
Do not fit tubed tyres.
Do not rotate tyres around the vehicle.
If the use of tyres not recommended by Land Rover is unavoidable, ensure that you read and fully comply with the tyre manufacturer’s instructions.

Ideally, tyres should be replaced in sets of 4. If this is not possible, replace the tyres in pairs (both front or both rear). When tyres are replaced, the wheels should always be re-balanced and alignment checked.

READ NEXT:

 Tyre pressure compensation for low ambient temperature changes

A colder ambient local temperature will reduce pressure within the tyre. An effect is to decrease sidewall height and to increase tyre shoulder wear with the potential for tyre failure. Vehicle dy

 Tyre pressure compensation - high ambient temperatures

 Flat spots due to long term parking

In order to minimise flat spotting, the tyre pressures can be increased to the maximum as stated on the tyre sidewall, for the period when the vehicle is stationary. Tyres must be returned to the

SEE MORE:

 Rear Side Member Closing Panel

Removal NOTES: The rear side member lower side extension is manufactured from DP600 with a mild steel mounting bracket. The panel is serviced less its weld studs. 1. The rear side member closing panel is replaced 2. For additional information relating to this repair procedure please see the foll

 After towing on four wheels

1. Apply the parking brake. For vehicles with an automatic gearbox, apply the footbrake and then select Park position. 2. Switch off the ignition and remove the Smart Key from the vehicle. 3. Remove the towing attachment and refit the cover panel to the front bumper. Use extreme caution when

© 2011-2025 Copyright www.rrevoque.org