Range Rover Evoque: Sensor blockage
Land Rover Range Rover Evoque L538 (2011–2018) Owner's Manual / Blind spot monitoring / Sensor blockage
If one of the sensors is completely obscured the BSM system is automatically disabled, the warning indicator dot is displayed in the exterior mirror and the message BSM sensor blocked appears in the message centre.
Note: Blockage testing is only initiated when vehicle speed is above 32km/h (20mph) and will take at least two minutes of accumulated driving above this speed, to determine that the sensor is blocked.
If the sensors become blocked, then please check that there is nothing obscuring the rear bumper and that it is clear from ice, frost and dirt.
Note: The BSM system is inoperative while a trailer is attached and the trailer socket is used.
READ NEXT:
System fault
If a fault with one of the radar sensors is
detected, an amber warning indicator dot is
displayed in the exterior mirror and the
message BSM not available is displayed in the
message centre.
Note
Garage door transceiver
Do not use the transceiver
with any
garage door opener that lacks the
safety stop and reverse feature as
required by safety standards.
When programming the transceiver to
a garage door opener
SEE MORE:
Wiper blade replacement
Fit only replacement wiper blades that are
identical to the original specification.
Before changing a wiper blade, the wiper arms
must be set in the ‘service’ position as follows;
Note: The Smart Key must remain in the
vehicle while wiper blades are replaced.
1. Ensure that the ignition is
Hill descent control (HDC) controls
Hill descent control (HDC) controls
1. Press to switch HDC on and off.
2. Press to increase the set speed.
3. Press to decrease the set speed.
Manual transmission: HDC can be used in 1st,
2nd or reverse gears.
Automatic transmission: HDC can be used in
D, R and CommandShift 1, 2 or 3.
Note
© 2011-2026 Copyright www.rrevoque.org
