Range Rover Evoque: Stop route guidance

To stop route guidance, proceed as follows: 1. Touch Nav menu on the map menu screen.

2. Touch the Stop guidance soft key.

READ NEXT:

 Quick poi selection

Touch the Map screen to display the POI button. Touch the POI (Point of interest) button. The screen shows six suggested categories, five of which can be selected as quick points of interest. Not

 Restore system defaults

If you have made any changes to the system’s default settings, use this menu to restore the original settings.

 Memory points

From the navigation menu, select Stored locations. This enables you to manage destinations such as, place of work, home, favourite restaurant or areas to avoid. From the Stored locations menu you

SEE MORE:

 Inner Back Panel Assembly

Removal NOTES: The inner back panel assembly is manufactured from mild steel. The panel is serviced less its weld studs. The new service panel is not fully spot welded when supplied. It is necessary to remove a section of one rear lamp mounting panel to enable removal and installation of the inn

 Rolling code device equipment programming

Note: The assistance of a second person, may make the following steps quicker and easier. Once the button has been pressed there are only 30 seconds in which to complete Step 3. 1. At the garage door opener receiver (motor head unit) in the garage, locate the learn or smart button/switch. - T

© 2011-2026 Copyright www.rrevoque.org