Range Rover Evoque: Transmission Control Module (TCM) GTDi 2.0L
Petrol
Removal
1. Disconnect the battery ground cable.
Refer to: Specifications (414-01 Battery, Mounting and Cables,
Specifications).
2. Refer to: Air Cleaner (303-12A Intake Air Distribution and Filtering -
TD4 2.2L Diesel, Removal and Installation).
3.

4.

5. CAUTION: Discard the component.

6.

7.

Installation
1. Torque: 25 Nm

2.

3. Torque:

4. CAUTION: Make sure that new components are
installed.
NOTE: Do not fully tighten the clamp at this
stage.

5. Torque: 10 Nm

6. Torque: 10 Nm

7. Refer to: Air Cleaner (303-12A Intake Air Distribution and Filtering -
TD4 2.2L Diesel, Removal and Installation).
8. Reconnect the battery ground cable.
Refer to: Specifications (414-01 Battery, Mounting and Cables,
Specifications).
9.
- Using the diagnostic tool, calibrate the transmission control
module (TCM).
- Using the diagnostic tool, re-calibrate the gear shift module
(GSM).
READ NEXT:
Special Tool(s)
307-597
Installer, Torque Converter Seal
307-613
Holding Pins, Torque Converter
Removal
NOTE: Some variation in the illustrations may occur, but the essential
information is always co
Special Tool(s)
205-857
Remover, Halfshaft
303-021
Engine support bracket
303-662
Support Beam Arm and Hook Assembly, Engine
JLR-303-1591
Lifting Bracket, Engine - Rear
General Equipment
Transmissio
Installation
NOTE: Some variation in the illustrations may occur, but the essential
information is always correct.
1. NOTE: This step is only required if previously removed.
Torque: 12 Nm
2. NOTE:
SEE MORE:
Component Location
COMPONENT LOCATION
Auxiliary battery module
Transmission Control Switch (TCS)
Upshift (+) paddle switch
Downshift (-) paddle switch
Transmission and Gear Shift Module (GSM) breathers
Automatic transmission
Gear Shift Module (GSM)
Transmission Control Module (TCM)
Transm
Torque Specifications
Turbocharger
Removal
NOTES:
Some illustrations may show the engine removed for clarity.
Some variation in the illustrations may occur, but the essential information is
always correct.
Removal steps in this procedure may contain installation details.
1. Disconnect the batter
© 2011-2026 Copyright www.rrevoque.org
