Range Rover Evoque: Using the repair kit
Avoid skin contact with the
sealant
which contains natural rubber latex.
Do not unscrew the sealant bottle from
the receiver until it is empty, as
sealant will leak out.
If the tyre inflation pressure does not
reach 1.8 bar (26 lb/in²) within seven
minutes, the tyre may have suffered
excessive damage. A temporary
repair will not be possible, and the
vehicle should not be driven until the
tyre has been replaced.
Before attempting a tyre
repair, ensure
that the vehicle is parked safely, as far
away from passing traffic as possible.
Ensure that the parking brake is applied,
and P is selected if an automatic
transmission is fitted.
Do not attempt to remove foreign
objects such as nails, screws, etc. from
the tyre.
Always run the engine when using the
compressor, unless the vehicle is in an
enclosed, or poorly ventilated space.
To prevent overheating do not operate
the compressor continuously for longer
than ten minutes.
Note: All vehicle drivers and occupants should be made aware that a temporary repair has been made to a tyre fitted to the vehicle. They should also be made aware of the special driving conditions imposed when using a repaired tyre.
READ NEXT:
Repair procedure
Check the tyre sidewall prior
to
inflation. If there are any cracks,
bumps or similar damage, do not
attempt to inflate the tyre. Do not
stand directly beside the tyre while
the compressor is
Checking the tyre pressure after a repair
When driving the vehicle, if
you
experience vibrations, abnormal
steering, or noises, reduce speed
immediately. Drive with extreme
caution and reduced speed to the first
safe place to stop the
SEE MORE:
Cleaning the exterior
Remove any heavy deposits of
mud and
dirt with a hose before washing the
vehicle.
Never aim a hose water jet directly at
the engine air intake, heater air intakes,
body seals or at any components which
may be damaged.
Do not use a high pressure washer or
steam cleaner in the engine
compa
Fender Apron Panel Front Reinforcement
Removal
NOTES:
The fender apron panel front reinforcement is manufactured from RP220 and
mild steel.
The panel is serviced less its weld studs
1. In this procedure, to make sure the vehicle is correctly aligned, it must
be placed on an
approved alignment jig.
2. The front side member and fender a
