Range Rover Evoque: Using wheel chocks

Note: Wheel chocks are not supplied as part of the tool kit.

Wheel chocks are a useful addition to a vehicle tool kit. Note the following advice when using wheel chocks.

the wheel Before raising the vehicle, the wheel diagonally opposite the one to be removed must be chocked.
Always chock the wheels using suitable wheel chocks. Place the chocks on both sides of the wheel diagonally opposite the wheel to be changed.
If jacking the vehicle on a slight slope is unavoidable, place the chocks on the downhill side of both wheels on the axle not being raised.

READ NEXT:

 Wheel changing safety

Before raising the vehicle or changing a wheel, ensure that you read and comply with the following warnings. Always find a safe place to stop, off the highway and away from traffic. Ensure tha

 Locking wheel nuts

Locking wheel nuts can be removed only by using the special adapter provided in the tool kit. Note: When the vehicle is first supplied, the adapter may be stored in the glove compartment. It shou

 Releasing locking wheel nuts

1. Insert the wheel nut adapter into the locking wheel nut, ensuring that it is fully engaged. 2. Locate the wheel brace over the adapter and unscrew the wheel nut half a turn counter clockwise.

SEE MORE:

 Rear Seat Backrest Cover 3-Door

Removal NOTES: This procedure covers the removal and installation of both rear seat backrests and the LH rear seat backrest cover. The RH rear seat backrest cover is similar. All notes and cautions must be followed strictly to avoid any chance of NVH or failure of the rear seat backrests. 5-door

 Engine Emission Control - GTDi 2.0L Petrol

Emission Control - Component Location COMPONENT LOCATION Intake manifold Bolt (8 off) Crankcase ventilation hose Oil separator Gasket Camshaft cover Lower clean air inlet duct Upper clean air inlet duct Camshaft cover vent hose Air cleaner housing Engine Emission Control - Overview OVER

© 2011-2026 Copyright www.rrevoque.org