Range Rover Evoque: Conditions causing automatic engine restart

The engine will automatically start if:<>
- climate control system demand increases
- the vehicle’s speed reaches approximately 4km/h (2.5mph)
- HDC or a Terrain Response special program are selected
- battery charge becomes low
- brake vacuum has been reduced (eg using the brake pedal repeatedly with the engine off)

READ NEXT:

 Disabling stop/start

Disabling stop/start To switch the system off (preventing automatic stop/start) press the ECO switch. The LED indicator will extinguish to confirm that the system is off. Note: The engine will

 Eco stall recovery

In the event that the engine stalls, it can be restarted by fully depressing the clutch pedal. Note: Automatic stall restart will only operate once. If the engine is stalled a second time the engi

 Emission control system

Land Rover vehicles are fitted with emission and evaporative control systems. In many countries it is unlawful to tamper, modify or replace such equipment and legal penalties apply if the laws are

SEE MORE:

 Rocker Panel

Removal NOTES: The rocker panel is manufactured from mild steel. Some of the butt joints must be MIG brazed due to the location of boron reinforcements. 1. This procedure identifies the method for the replacement of the rocker panel in full. The graphic and table identify possible alternative sec

 Transfer Case Connecting Sleeve Seals GTDi 2.0L Petrol

Special Tool(s) 100-012 Slide Hammer 307-594 Installer, Seal 308-005 Remover, Axle oil seal Removal NOTE: Some variation in the illustrations may occur, but the essential information is always correct. 1. WARNING: Make sure to support the vehicle with axle stands. Raise and support the vehicle. 2.

© 2011-2025 Copyright www.rrevoque.org