Range Rover Evoque: Daytime running lamps
Daytime running lamps are LED lamps.
With the lighting control in the OFF position or
in AUTO position while lighting conditions do
not require headlamps on, then daytime
running lamps will switch on automatically
under the following conditions:
- The engine is running.
- The gear selector is out of park (automatic
transmission).
- The parking brake is not applied - market
dependent.

Unless required or prohibited by law,
daytime running lamps can be disabled
or enabled by your Dealer/Authorised
Repairer.
READ NEXT:
This feature operates whenever the lamps
master switch is in the AUTO (5) position and
the ignition is turned off. The headlamps will
remain illuminated for up to 240 seconds.
Note: The time delay
This feature of the Xenon lighting automatically
selects and deselects high beam, under
specific conditions of road lighting and in the
absence of other vehicle’s lights. The system is
only acti
If Auto lamps is selected and the windscreen
wipers are switched on for 20 seconds or
more, the side lamps, tail lamps and
headlamps will switch on automatically. When
the wipers are switched off,
SEE MORE:
Special Tool(s)
303-1300
Remover, Crankshaft Seal
303-882
Installer, Halfshaft Seal
Removal
1. WARNING: Make sure to support the vehicle with axle stands.
Raise and support the vehicle.
2. Refer to: Front Halfshaft RH - LHD AWD/RHD AWD (205-04 Front
Drive Halfshafts, Removal and Installation).
3. CA
Hydraulic Brake Actuation LHD AWD/RHD AWD - Component Location
NOTE: RHD (right-hand drive) installation shown, LHD (left-hand drive)
installation similar.
COMPONENT LOCATION
Brake pedal
Hydraulic pipes
Integrated HCU (hydraulic control unit) and ABS (anti-lock brake system)
module
Brake ma
© 2011-2026 Copyright www.rrevoque.org
