Range Rover Evoque: Diesel misfuelling protection device

activated, it may cause fuel to be When the misfuelling device is activated, it may cause fuel to be discharged from the filler neck.

Note: It is the driver’s responsibility to fill the vehicle with the correct fuel. The diesel misfuelling protection device only reduces the risk of filling the vehicle with the incorrect fuel.

Diesel engine vehicles in some markets are equipped with a misfuelling protection device, incorporated into the fuel filler neck.

If the narrow filler nozzle fitted to pumps delivering unleaded petrol is fully inserted into the filler neck, the misfuel protection device will activate.

Note: The filler spout on some fuel cans and older fuel pumps may trigger the misfuelling device.

When activated, the yellow misfuel protector will be visible inside the filler neck. It will prevent fuel flow into the tank. Before fuelling can continue with the correct fuel, the device will need to be reset.

The reset tool is located in the luggage compartment.

Reset the misfuel protection device as follows:

Reset the misfuel protection device as follows: 1. Insert the reset tool with the teeth uppermost, as far as it will go into the filler neck.

2. Locate the teeth by pushing down the top of the reset tool.

3. WIth the top of the tool pressed down and the teeth engaged, slowly pull the tool out of the filler neck to reset the device.

once the teeth Do not twist the device, once the teeth have engaged.

Note: The yellow part of the protection device should no longer be visible in the filler neck.

Return the reset tool to the luggage compartment.

READ NEXT:

 Fuel tank capacity

Avoid the risk of running out of fuel and never intentionally drive the vehicle when the fuel gauge indicates that the tank is empty. When refuelling your vehicle after the fuel gauge reads empty,

 Fuel specification

Diesel vehicles in Algeria, Egypt, Libya, Morocco, India, Pakistan and Tunisia must only use premium diesel fuel.

 Fuel consumption

The fuel consumption figures shown below have been calculated using a standard testing procedure (the new EC test procedure from Directive 99/100/EC), and produced in accordance with The Passeng

SEE MORE:

 Rear Disc Brake

General Specification Torque Specifications * New nuts/bolts must be installed Brake Pads Removal WARNING: Brake pads must be renewed in axle sets only. Failure to follow this instruction may result in braking efficiency being impaired. CAUTION: LH illustration shown, RH is similar. 1. Connect th

 Front Side Member

Removal NOTES: The front side member is manufactured from RP260 and DP600. The front side member long section is cut from the front side member and is manufactured from RP260. The service panel is serviced not fully spot welded. 1. In this procedure, to make sure the vehicle is correctly aligned,

© 2011-2026 Copyright www.rrevoque.org