Range Rover Evoque: Engine starting: manual transmission

Note: Do not press the accelerator pedal when starting the engine.

1. A valid Smart Key must be inside the vehicle.

2. Fully depress the clutch pedal.

3. Press and release the start button. For diesel engined vehicles there may be a delay while the glow plugs warm up, then the engine will crank automatically until it starts.

READ NEXT:

 If the engine fails to start

Note: If the engine fails to crank when the START/STOP button is pressed and there has been a recent collision, seek qualified assistance. If the engine fails to crank, or fails to start, consult

 Switching off the engine

Before switching off the engine, ensure that the vehicle is parked safely with the park brake applied. 1. Select P for automatic transmission, or neutral for manual transmissions. Note: If any ot

 Switching off the engine with the vehicle moving

It is not advisable to switch off the engine while the vehicle is moving. However, should such a situation arise, then the following procedure applies. - Press and hold the engine START/STOP

SEE MORE:

 System fault

If a fault with one of the radar sensors is detected, an amber warning indicator dot is displayed in the exterior mirror and the message BSM not available is displayed in the message centre. Note: Even if the detected fault only affects the radar sensor on one side of the vehicle, the whole s

 Control Diagram, System Operation

Control Diagram NOTE: A = Hardwired; D = High Speed CAN Bus; O = Local Interconnect Network (LIN) Bus CONTROL DIAGRAM - SHEET 1 OF 2 Battery Starter motor fuse Battery Junction Box (BJB) Starter motor Generator Transmission Control Module (TCM) Cooling fan control module Air Conditioning

© 2011-2026 Copyright www.rrevoque.org