Range Rover Evoque: Government end users

If the DATABASE is for a region of North America and is being acquired by or on behalf of the United States government or any other entity seeking or applying rights similar to those customarily claimed by the United States government, the DATABASE is licensed with ‘limited rights’.

Utilization of the DATABASE is subject to the restrictions specified in the ‘Rights in Technical Data and Computer Database’ clause at DFARS 252.227–7013, or the equivalent clause for non-defence agencies. Manufacturer of the DATABASE of North America is NAVTEQ Corporation, 10400 W. Higgins Road, Suite 400, Rosemont, Illinois 60018, USA.

READ NEXT:

 European declaration of conformity

Hereby, DENSO CORPORATION declares that this DN-NS-019 is in compliance with the essential requirements and other relevant provisions of Directive 1999/5/EC.

 Fuel and refuelling

 Safety precautions

Avoid exposing the fuel gasses to any potential sources of ignition as the resulting fire and explosion may cause serious injuries and/or death. Switch off the engine when refuelling, as it is

SEE MORE:

 Rear Disc Brake

General Specification Torque Specifications * New nuts/bolts must be installed Brake Pads Removal WARNING: Brake pads must be renewed in axle sets only. Failure to follow this instruction may result in braking efficiency being impaired. CAUTION: LH illustration shown, RH is similar. 1. Connect th

 Transfer Case Connecting Sleeve Seals GTDi 2.0L Petrol

Special Tool(s) 100-012 Slide Hammer 307-594 Installer, Seal 308-005 Remover, Axle oil seal Removal NOTE: Some variation in the illustrations may occur, but the essential information is always correct. 1. WARNING: Make sure to support the vehicle with axle stands. Raise and support the vehicle. 2.

© 2011-2025 Copyright www.rrevoque.org