Range Rover Evoque: Locking wheel nuts
Land Rover Range Rover Evoque L538 (2011–2018) Owner's Manual / Wheel changing / Locking wheel nuts
Locking wheel nuts can be removed only by using the special adapter provided in the tool kit.
Note: When the vehicle is first supplied, the adapter may be stored in the glove compartment. It should be removed and stored in the tool kit as soon as possible.
Note: A code number is stamped onto the underside of the adapter. If a replacement adapter is required, you will be asked to quote this number. Ensure that the number is recorded and kept safe, but should not be kept with the vehicle.
READ NEXT:
Releasing locking wheel nuts
1. Insert the wheel nut adapter into the
locking wheel nut, ensuring that it is fully
engaged.
2. Locate the wheel brace over the adapter
and unscrew the wheel nut half a turn
counter clockwise.
Wheel changing
WARNING - THAT NO PERSON
SHOULD PLACE ANY PORTION OF
THEIR BODY UNDER A VEHICLE THAT
IS SUPPORTED BY A JACK.
Position the jack from the side of the
vehicle, in line with the appropriate
jacking
SEE MORE:
B-Pillar Lower Trim Panel, D-Pillar Trim Panel
B-Pillar Lower Trim Panel
Removal
NOTE: Removal steps in this procedure may contain installation details.
1.
2.
3.
4. CAUTION: Discard the bolt.
Torque: 45 Nm
5.
6.
Installation
1. WARNING: Make sure that a new bolt is installed.
CAUTION: Make sure the safety belt is secure and correctly
inst
Changing a bulb
If the lighting has just
been switched
off, give the bulbs time to cool.
Handling them when hot may cause
personal injury.
Always replace bulbs with
the correct
type and specification. If you are in any
doubt contact your Land Rover
Dealer/Authorised Repairer for advice.
See 199, BULB
© 2011-2025 Copyright www.rrevoque.org
