Range Rover Evoque manuals

Range Rover Evoque: Lower Arm

Land Rover Range Rover Evoque L538 (2011–2018) Service Manual / Suspension / Front Suspension / Lower Arm

Removal

CAUTION: Nuts and bolts must be tightened with the weight of the vehicle on the suspension.

NOTES:

RH illustration shown, LH is similar.

Removal steps in this procedure may contain installation details.

1. WARNING: Make sure to support the vehicle with axle stands. Raise and support the vehicle.

2. Refer to: Wheel and Tire (204-04 Wheels and Tires, Removal and Installation).

3. WARNING: Make sure that a new nut is installed. Torque: 60 Nm

Range Rover Evoque. Front Suspension

4.

Range Rover Evoque. Front Suspension

5. WARNING: Make sure that a new bolt is installed. Torque: 200 Nm

Range Rover Evoque. Front Suspension

6. WARNING: Make sure that a new bolt is installed.

Torque:

Stage 1: 48 Nm
Stage 2: 180

READ NEXT:

 Front Stabilizer Bar AWD

Removal CAUTION: Nuts and bolts must be tightened with the weight of the vehicle on the suspension. NOTES: Only use clean water as a lubricant for the bushing, if required. Removal steps in this pro

 Front Stabilizer Bar Bushing

Removal NOTES: Some variation in the illustrations may occur, but the essential information is always correct. Removal steps in this procedure may contain installation details. 1. WARNING: Make sure

 Wheel Knuckle

Special Tool(s) 205-754A Splitter, Ball Joints 205-857 Remover, Halfshaft JLR-204-804 Lever, Wheel Knuckle Removal CAUTIONS: Nuts and bolts must be tightened with the weight of the vehicle on the sus

SEE MORE:

 Keyless start backup

If the vehicle has been unlocked using the emergency key blade or the Smart Key is not detected by the vehicle, it will be necessary to use the keyless start backup to disarm the alarm and start the engine. The keyless start backup can only be used when the message Smart Key Not Found Refer t

 Transmission Vehicles With: M66 6-Speed Manual Transmission AWD - Installation

Installation Special Tool(s) 303-021 Engine support bracket 303-662 Support Beam Arm and Hook Assembly, Engine NOTE: Some variation in the illustrations may occur, but the essential information is always correct. 1. NOTE: This step is only required if previously removed. 2. NOTE: This step is only

© 2011-2025 Copyright www.rrevoque.org