Range Rover Evoque: Maximum defrost

Press to remove frost or heavy misting from the front screen. The system will adjust the front blower output for maximum clearing. In addition the rear screen and optional front screen heaters will be activated.

Press again to switch off defrost mode. The screen heaters will remain on.

READ NEXT:

 Air distribution control

An LED will illuminate in the selected switches.

 Heated screens

Press to operate the required screen heater. The screen heater(s) will operate for a predetermined timed period before automatically switching off. Do not attach labels to the rear screen. Do

 Front seat heaters

Press the relevant button to operate the required seat heater at high level. Three indicators will illuminate. Press a second time to heat the seat at a medium level. Two indicators will illuminat

SEE MORE:

 Transmission Control Module (TCM), Gear Shift Module (GSM)

TRANSMISSION CONTROL MODULE (TCM) TCM Neutral 'N' position Park 'P' position Position sensor/manual shaft Electrical connector The TCM is located on the top of the transmission casing and is connected on the high speed CAN (controller area network) bus to send and receive information to and

 Front Stabilizer Bar AWD

Removal CAUTION: Nuts and bolts must be tightened with the weight of the vehicle on the suspension. NOTES: Only use clean water as a lubricant for the bushing, if required. Removal steps in this procedure may contain installation details. 1. WARNING: Make sure to support the vehicle with axle stan

© 2011-2026 Copyright www.rrevoque.org