Range Rover Evoque: Power Transfer Unit TD4 2.2L Diesel
Removal
NOTE: Removal steps in this procedure may contain installation details.
All vehicles
1. WARNING: Make sure to support the vehicle with axle stands. Raise and support the vehicle.
2. Refer to: Front Halfshaft RH - LHD AWD/RHD AWD (205-04 Front Drive Halfshafts, Removal and Installation).
3. Refer to: Engine Undershield (501-02 Front End Body Panels, Removal and Installation).
4. Torque:
- M6 12 Nm
- Clamp 3.5 Nm
5. Torque:
- M8 12 Nm
- Clamp 3.5 Nm
Vehicles with diesel particulate filter (DPF)
6.
All vehicles
7. CAUTIONS: Mark the position of the driveshaft flange in relation to the drive pinion flange.
To avoid damage to the joint or gaiter, do not allow the driveshaft to hang.
To avoid damage to the joint or gaiter, do not allow the driveshaft to hang.
Torque: 40 Nm
8. CAUTIONS: Discard the bolt.
Make sure that a new bolt is installed.
Torque:
- Stage 1: 50 Nm
- Stage 2: 180
READ NEXT:
Transfer Case
Connecting Sleeve Seals GTDi 2.0L Petrol
Special Tool(s)
100-012
Slide Hammer
307-594
Installer, Seal
308-005
Remover, Axle oil seal
Removal
NOTE: Some variation in the illustrations may occur, but the essential
information is always correc
Transfer Case
Connecting Sleeve Seals TD4 2.2L Diesel, Vehicles With: AWF21 6-Speed
Automatic Transmission
Special Tool(s)
100-012
Slide Hammer
307-594
Installer, Seal
308-005
Remover, Axle oil seal
Removal
NOTE: Some variation in the illustrations may occur, but the essential
information is always correc
Transfer Case
Connecting Sleeve Seals TD4 2.2L Diesel, Vehicles With: M66 6-Speed
Manual Transmission AWD
Special Tool(s)
100-012
Slide Hammer
303-1300
Remover, Crankshaft Seal
303-538
Remover/Installer, Crankshaft Oil Seal
307-594
Installer, Seal
307-595
Installer, Intermediate Shaft Seal
308-615
Remover
SEE MORE:
Bolt and Nut Identification
An ISO metric bolt or screw made of steel and larger than 6 mm in diameter
can be identified by either of the symbols ISO
M or M embossed or indented on top of the bolt head.
In addition to marks identifying the manufacturer, the top of the bolt head
is also marked with symbols indicating the
st
Electronic Engine Controls
Principles of Operation
For a detailed description of the 2.0L GTDi petrol electronic engine
controls, refer to the relevant Description and Operation
section in the workshop manual. REFER to: (303-14B Electronic Engine Controls -
GTDi 2.0L Petrol)
Inspection and Verification
CAUTION: Diagnosis by
