Range Rover Evoque: Rolling re-start
Land Rover Range Rover Evoque L538 (2011–2018) Owner's Manual / Starting the engine / Rolling re-start
If the engine is switched off while the vehicle is moving, a rolling re-start can be initiated.
Automatic transmission - select neutral (N) and then press the engine START/STOP button.
When the engine re-starts, select transmission position D.
Manual transmission - depress the clutch and then press the engine START/STOP button.
When the engine re-starts, select an appropriate forward gear.
READ NEXT:
Keyless start backup
If the vehicle has been unlocked using the
emergency key blade or the Smart Key is not
detected by the vehicle, it will be necessary to
use the keyless start backup to disarm the
alarm and start t
Stop/start (manual transmission only)
The Stop/Start system has been designed to
improve fuel efficiency. The system is
automatically activated when the ignition is
switched on.
When the engine has been stopped by the
stop/start syst
Conditions preventing automatic engine stop
The engine will not automatically stop if:<>
- the external temperature is below approximately 0°C (32°F)
- the external temperature is above approximately40°C (104°F)
- engine has not re
SEE MORE:
Component Description
DESCRIPTION
Engine Control Module (ECM)
The ECM is located at the rear of the engine compartment, between the
bulkhead and the engine sound insulation. The ECM is located in a plastic molded
carrier which in turn is located in a bracket attached to the vehicle structure.
The ECM is connected to t
Wiring Harness - Description and Operation
Introduction
CAUTION: Do not use any other heat shrink sleeve other than the approved
glue lined heat shrink sleeve mentioned
in the repair procedure.
The purpose of this document is to promote quick and efficient minor repair
to harness connectors or cables using
approved methods and the wiring
© 2011-2025 Copyright www.rrevoque.org
