Range Rover Evoque: Suspending and resuming cruise control

Suspend cruise control with a single press of control (3).

To resume cruise control at the previous set speed, press control (2).

if the RES (2) should be used only if the driver is aware of the set speed and intends to return to it.
It is not recommended to resume set speed when a low gear is selected as excessive engine speeds will occur.

READ NEXT:

 Automatic switch off

Cruise control will switch off but the set speed will remain in the memory when: - The CAN button (3) is pressed. - The brake pedal is pressed. - Speed falls below 30km/h (18mph). - Neutral, Park

 Cruise eco data

Diesel only When enabled, a CO2 emission indicator is displayed in the message centre. The higher the numeric reading, the more CO2 is being emitted and the more fuel is being used. See 56, VEH

 Stability control

SEE MORE:

 Supervisor screen controls

Supervisor screen controls See 104, TOUCH SCREEN OVERVIEW. 1. Select rear media. 2. Current rear media display. 3. Left screen select. 4. Right screen select. 5. Settings screen. 6. Remote control lock. 7. Turns off the selected screen. 8. Turns off the selected system. 9. Audio source s

 Central Junction Box (CJB)

Removal CAUTIONS: If a new component is to be installed, the Land Rover approved diagnostic equipment must be connected prior to removal, the data must then be downloaded from it and the keys (remote control handsets) set into default mode. Failure to follow this instruction will result in permane

© 2011-2026 Copyright www.rrevoque.org