Range Rover Evoque: Trailer electrical connection
Land Rover Range Rover Evoque L538 (2011–2018) Owner's Manual / Towing / Trailer electrical connection
Connect only approved
electrical
circuits, which are in good condition, to
the trailer socket.
The vehicle connector provides a 5 amp output which must not be exceeded. An accessory harness kit increasing output to 15 amp is available from your Land Rover Dealer.
When a trailer electrical connection is made and the vehicle’s direction indicators are used, the trailer warning indicator will flash in time with the direction indicators.
READ NEXT:
Powered tailgate
When towing, ensure there is
sufficient
clearance before opening or closing the
tailgate.
Parking aids
The rear parking aids sensors are automatically
disabled when a trailer with an approved
electrical connector is connected.
Note: Trailers fitted with LED lights will not
disable the rear parking
Trailer stability assist (TSA)
When a trailer is attached, TSA will
automatically detect when a trailer sway is
developing. It will then gradually reduce vehicle
speed by cutting engine power and applying
the brakes to help reg
SEE MORE:
Suspension System - General Information
Coil Spring Suspension
Wheel Alignment Specification (All Markets) - Front
NOTE: All figures are with vehicle at 'Showroom' ride height - full
fluids, full tank of fuel, no occupants/luggage, tires
inflated to normal pressures
Wheel Alignment Specification (All Markets) - Rear
NOTE: All figures a
C-Pillar Upper Trim Panel
Removal
NOTE: Removal steps in this procedure may contain installation details.
1.
2.
3.
4.
5. Torque: 6 Nm
6.
Installation
1. To install, reverse the removal procedure.
C-Pillar Lower Trim Panel
Removal
1. Refer to: Rear Seat Cushion (501-10 Seating, Removal and
Installation).
2. Refer to: Lo
© 2011-2025 Copyright www.rrevoque.org
