Range Rover Evoque: Transmission Fluid Pan TD4 2.2L Diesel
Removal
CAUTION: Extreme cleanliness must be exercised when handling this component.
NOTE: Some variation in the illustrations may occur, but the essential information is always correct.
1. WARNING: Make sure to support the vehicle with axle stands. Raise and support the vehicle.
2. Refer to: Transmission Fluid Drain and Refill (307-01 Automatic Transmission/Transaxle - Vehicles With: AWF21 6-Speed Automatic Transmission, General Procedures).
3.
4.
5. CAUTION: Be prepared to collect escaping oil.
6. CAUTION: Be prepared to collect escaping oil.
7. Carefully remove the sealant.
Installation
1. For sealant specification, refer to the specifications section.
Refer to: Specifications (307-01 Automatic Transmission/Transaxle - Vehicles With: AWF21 6-Speed Automatic Transmission, Specifications).
2. CAUTION: Make sure that the mating faces are clean and free of foreign material. Apply a bead of sealant, 3 mm diameter, to the area indicated.
3. Torque: 14 Nm
4. Torque: 10 Nm
5. Torque: 12 Nm
6. Torque: 12 Nm
7 Refer to: Transmission Fluid Drain and Refill (307-01 Automatic Transmission/Transaxle - Vehicles With: AWF21 6-Speed Automatic Transmission, General Procedures).
Main Control Valve Body GTDi 2.0L Petrol
Removal
NOTE: Removal steps in this procedure may contain installation details.
1. WARNING: Make sure to support the vehicle with axle stands. Raise and support the vehicle.
2. Disconnect the battery ground cable.
Refer to: Specifications (414-01 Battery, Mounting and Cables, Specifications).
3. Refer to: Transmission Fluid Pan - GTDi 2 0L Petrol (307-01 Automatic Transmission/Transaxle - Vehicles With: AWF21 6-Speed Automatic Transmission, Removal and Installation).
4. CAUTIONS:
Take extra care not to damage the wiring harnesses.
Note the fitted position of the component prior to removal.
Torque: 10 Nm
5.
6.
Installation
1. CAUTION: Tighten the bolts in the sequence shown. Torque: 10 Nm
2. To install, reverse the removal procedure.
READ NEXT:
Transmission TD4 2.2L Diesel - Removal
Removal
Special Tool(s)
205-857
Remover, Halfshaft
303-021
Engine support bracket
303-662
Support Beam Arm and Hook Assembly, Engine
General Equipment
Transmission jack
NOTE: Some variation in the
Transmission TD4 2.2L Diesel - Installation
Installation
Special Tool(s)
303-021
Engine support bracket
303-662
Support Beam Arm and Hook Assembly, Engine
NOTE: Some variation in the illustrations may occur, but the essential
information is al
Transmission Fluid Pan GTDi 2.0L Petrol
Removal
CAUTION: Extreme cleanliness must be exercised when handling this
component.
NOTE: Some variation in the illustrations may occur, but the essential
information is always correct.
1. WARNING
SEE MORE:
Headlamp Adjustment
NOTE: The headlamp setting is 1.2 % below horizontal and parallel.
1. Align the headlamp beam setting equipment to one headlamp.
2. Switch the headlamps on and to dipped beam.
3. NOTE: NAS vehicles have vertical adjustment only.
Adjust the headlamps with an Allen Key.
Rotate the adjuster 'A' for
Oil Pump
Removal
NOTES:
Some illustrations may show the engine removed for clarity.
Some variation in the illustrations may occur, but the essential information is
always correct.
Removal steps in this procedure may contain installation details.
1. Refer to: Specifications (414-01 Battery, Mounting and Ca
