Range Rover Evoque: Using traction devices

heavy Only use traction devices in heavy snow conditions, on hard road surfaces.
Dynamic Stability Control (DSC) must be switched off when using traction devices.
Never exceed 50 km/h (30 mph) when traction devices are fitted.
Never fit traction devices to a temporary use spare wheel.

Land Rover approved traction devices may be used to improve traction on a hard road surface in heavy snow conditions. They should not be used in off-road conditions.

If it becomes necessary to fit traction devices, the following points must be observed: - Only Land Rover approved traction devices should be used on the vehicle. Only Land Rover approved traction devices have been tested to ensure that they do not cause damage to the vehicle. Contact your Land Rover Dealer/Authorised Repairer for information.

- The wheels and tyres fitted must conform to the specifications of the original equipment.

- Do not fit traction devices to 18, 19 or 20inch diameter wheels.

- Single sided Spike-spyder traction devices or snow chains can be fitted to only the front wheels of vehicles fitted with 17inch diameter wheels.

- Always read, understand and follow the traction device manufacturer's instructions.

- Avoid tyre/vehicle damage, by removing the traction devices as soon as the conditions allow.

READ NEXT:

 Tpms inflation pressure compensation

If your vehicle is fitted with 18, 19 or 20 inch wheels with TPMS, they can be replaced with 17 inch wheels with TPMS, so enabling the use of snow chains or traction devices. Tyre pressures of veh

 Vehicle recovery

 Recovery

The method for recovery/ transportation of the vehicle is on a transporter or trailer designed for that purpose. Ensure that transportation is carried out by suitably qualified person and that the

SEE MORE:

 Rear Side Member Section

Removal NOTES: The rear side member section is manufactured from RP260, with its inner reinforcement manufactured from DP600. The rear side member section is cut from the rear side member service panel, the section also includes the upper and lower side extensions. 1. In this procedure, to make s

 Speed Control

Speed Control Actuator Removal 1. Refer to: Accelerator Pedal (310-02 Acceleration Control, Removal and Installation). Installation 1. To install, reverse the removal procedure. Speed Control Deactivator Switch Removal NOTE: Removal steps in this procedure may contain installation details. 1. CAUTI

© 2011-2025 Copyright www.rrevoque.org