Range Rover Evoque: Window reset

If the battery is disconnected or the power supply is interrupted, the windows must be reset.

Once the power supply is restored, reset as follows: 1. Close the window fully.

2. Release the switch, then lift it to the close position and hold for 1 second.

3. Repeat the procedure on each window.

READ NEXT:

 Anti-trap protection

Closing a window or roof blind onto any part of the body can result in serious injury. Before closing a window or the roof blind, ensure that no occupants have any part of their body in a posi

 Resonance with lowered windows

if a resonance or booming sound occurs when a rear window is open, lowering an adjacent front window by approximately 25mm (1 inch) will eliminate the condition.

 Mirrors

SEE MORE:

 Inner Back Panel Assembly

Removal NOTES: The inner back panel assembly is manufactured from mild steel. The panel is serviced less its weld studs. The new service panel is not fully spot welded when supplied. It is necessary to remove a section of one rear lamp mounting panel to enable removal and installation of the inn

 Component Description

DOOR LATCHES Door interior lock/unlock button Door interior release handle Door lock exterior release cable Emergency mechanical door lock (front LH door only) Exterior door handle lock cover Exterior door handle Door latch Electrical connection to door control module Door lock interior r

© 2011-2026 Copyright www.rrevoque.org