Range Rover Evoque: Airbag service information

repair, Do not attempt to service, repair, replace, modify, or tamper with, any part of the SRS. This includes wiring or components in the vicinity of SRS components. Doing so may cause the system to trigger, or render the system inoperative.
Do not use any electrical test equipment or devices in the vicinity of SRS components or wiring. Doing so may cause the system to trigger, or render the system inoperative.

All of the following operations should be carried out only by a Dealer/Authorised Repairer, or suitably qualified person:
- Removal or repair of any wiring or component in the vicinity of any SRS components.

- Installation of electrical, or electronic, equipment and accessories.

- Modification to the front or sides of the vehicle exterior.

- Attachment of accessories to the front or sides of the vehicle.

READ NEXT:

 Disability modifications

Occupants with disabilities which may require modification of the vehicle, must contact a Dealer/Authorised Repairer before any modifications are made.

 Exterior lights

 Lighting control

Lighting control 1. With the headlamps on, push the control away from the steering wheel to select high beam. The instrument pack warning lamp will illuminate. Note: Do not use high beam where

SEE MORE:

 Condenser GTDi 2.0L Petrol

Removal CAUTION: Make sure that all openings are sealed. Use new blanking caps. NOTES: Some variation in the illustrations may occur, but the essential information is always correct. Removal steps in this procedure may contain installation details. 1. Disconnect the battery ground cable. Refer t

 Fuel Filter

Special Tool(s) 310-123 Locking Ring, Fuel Tank Removal WARNINGS: Wait for a minimum of 1 minute after the engine has stopped before carrying out any repair to the fuel injection system. Avoid flames, sparks or lighted substances. CAUTION: Be prepared to collect escaping fuel. NOTE: Removal step

© 2011-2026 Copyright www.rrevoque.org