Range Rover Evoque: B-Pillar Lower Trim Panel, D-Pillar Trim Panel
B-Pillar Lower Trim Panel
Removal
NOTE: Removal steps in this procedure may contain installation details.
1.

2.

3.

4. CAUTION: Discard the bolt.
Torque: 45 Nm

5.

6.

Installation
1. WARNING: Make sure that a new bolt is installed.
CAUTION: Make sure the safety belt is secure and correctly
installed.
NOTE: Make sure the safety belt is operating correctly.
To install, reverse the removal procedure.
D-Pillar Trim Panel
Removal
NOTE: Removal steps in this procedure may contain installation details.
All vehicles
1.

2. NOTE: LH side only.

3.

5-door
4.

3-door
5.

All vehicles
6. Torque: 6 Nm

7.

8.

Installation
1. To install, reverse the removal procedure.
READ NEXT:
Removal
NOTE: Removal steps in this procedure may contain installation details.
All vehicles
1. Torque: 6 Nm
2. Torque: 6 Nm
3. Torque: 0.9 Nm
4. Torque: 1.3 Nm
5-door
5.
3-door
6.
All vehicles
Removal
NOTE: Removal steps in this procedure may contain installation details.
1. Torque: 1.3 Nm
2. Torque: 6 Nm
3. Torque: 6 Nm
4.
5.
6.
7. NOTE: Do not disassemble further if the
component is
Removal
NOTES:
Removal steps in this procedure may contain installation details.
Vehicles with glass roof panel shown, vehicles without glass roof panel similar.
All vehicles
1. Refer to: Windshield
SEE MORE:
The seat belt pre-tensioners activate in
conjunction with the SRS to provide additional
protection in the event of a severe frontal
impact. They automatically reduce any slack in
a seat belt to reduce forward movement of a
front seat occupant.
The seat belt pre-tensioners
will
activate onl
Anti-Theft - Active - Component Location
COMPONENT LOCATION
RH (right-hand) front door module
RH front door latch mechanism
Radio Frequency (RF) receiver
RH rear door module
RH rear door latch mechanism
Interior motion sensor
Remote handset
Liftgate latch mechanism
Keyless Vehicle Module
© 2011-2026 Copyright www.rrevoque.org
