Range Rover Evoque: Dual view selection
Land Rover Range Rover Evoque L538 (2011–2018) Owner's Manual / Dual view / Dual view selection
When the ignition is switched on or the audio unit is turned on after being turned off, single view mode will be the default view.
To select dual view, press the dual view hard key on the fascia surround. See 111, AUDIO/VIDEO CONTROLS.
Press again to display the dual view Options menu. From here, a change can be made to the viewing source or dual view can be cancelled.
If TV or a video format source were being viewed previously, the same source will be displayed.
READ NEXT:
Dual view control menu
Dual view control menu
1. Select to cancel dual view and revert to the
menu for the current video source (TV,
DVD).
Note: The preview screen will be
deactivated if the vehicle is moving.
2. Se
Dual view tv operation
If you would like to change the TV programme
while the vehicle is moving, there are two
methods available;
1. Press the dual view hardkey to display the
control menu.
Select an alternative channe
Dual view video operation
When the video programme begins play, a root
menu with information about the video
programme and its content will be displayed on
screen.
Note: Information and style may vary due to
differing vid
SEE MORE:
Transmission Control Module (TCM)
CAUTION:
Diagnosis by substitution from a donor vehicle is NOT acceptable. Substitution
of control modules does
not guarantee confirmation of a fault, and may also cause additional faults in
the vehicle being tested and/or the donor
vehicle
NOTES:
If the control module or a component
Rear Side Member Section
Removal
NOTES:
The rear side member section is manufactured from RP260, with its inner
reinforcement manufactured from DP600.
The rear side member section is cut from the rear side member service panel, the
section also includes the upper and lower side
extensions.
1. In this procedure, to make s
© 2011-2025 Copyright www.rrevoque.org
