Range Rover Evoque manuals

Range Rover Evoque: Engine Cooling - Component Location, System Operation and Component Description

Land Rover Range Rover Evoque L538 (2011–2018) Service Manual / Engine / Engine Cooling - GTDi 2.0L Petrol / Engine Cooling - Component Location, System Operation and Component Description

Component Location

COMPONENT LOCATION

Range Rover Evoque. Engine Cooling - GTDi 2.0L Petrol

  1. Heater core
  2. Air Conditioning (A/C) Evaporator (ref only)
  3. Heater inlet hose
  4. Heater outlet hose/Oil cooler inlet hose
  5. Turbocharger water outlet pipe
  6. Water outlet
  7. Transmission fluid cooler
  8. Electric cooling fan - Left Hand (LH)
  9. Radiator top hose
  10. By-pass hose
  11. Degas tank
  12. Charge air cooler (reference only)
  13. Electric cooling fan - Right Hand (RH)
  14. Thermostat and housing
  15. Water pump
  16. Block heater (where fitted)
  17. Engine oil cooler
  18. Turbocharger
  19. Turbocharger water inlet pipe
  20. Radiator bottom hose
  21. Engine coolant drain plug
  22. Transmission oil cooler (hot climate markets only)
  23. A/C condenser (reference only)
  24. Engine cooling radiator

Overview

OVERVIEW

The pressurized cooling system allows coolant to circulate around the engine and the heater circuit while the thermostat main valve is closed. The primary function of the cooling system is to maintain the engine within an optimum temperature range under changing ambient and engine operating conditions. Secondary functions are to provide automatic transmission fluid cooling, turbocharger cooling and interior cabin heating.

When the engine is running the coolant is circulated around the engine cooling system by the coolant pump. From the coolant pump, coolant flows through the cylinder block and the cylinder heads. Some of the coolant leaving the engine is directed through the turbocharger before returning to the water outlet.

The main engine thermostat is located at the engine inlet up-stream of the water pump. During initial engine warm up the thermostat main valve is closed: preventing coolant flow through the radiator and transmission cooler. When the thermostat main valve is closed, coolant is circulated through the bypass circuit, cabin heater, engine oil cooler and degas tank to allow these systems to function during warm up.

Once the coolant temperature exceeds the thermostat start to open temperature of 82-90

READ NEXT:

 Cooling System Draining, Filling and Bleeding

Draining CAUTIONS: The engine cooling system must be maintained with the correct concentration and type of anti-freeze solution to prevent corrosion and frost damage. Failure to follow this instructi

 Radiator

Removal NOTES: Removal steps in this procedure may contain installation details. Some variation in the illustrations may occur, but the essential information is always correct. 1. WARNING: Make sure

 Cooling Fan

Removal NOTES: Removal steps in this procedure may contain installation details. Some variation in the illustrations may occur, but the essential information is always correct. 1. WARNING: Make sure

SEE MORE:

 Rds-tmc icons

Any traffic event (broadcast on TMC) in your area, will be displayed as a warning icon on the map and an alert may be displayed as a message giving the road number(s) and between which junctions the hold-up or event occurs. This data is stored in the system for up to of 30 minutes. The colou

 Navigation System

Navigation System Principles of Operation NOTE: This navigation system is installed in selected Asia market vehicles only. For a detailed description of the navigation system, refer to the relevant Description and Operation section of the workshop manual. REFER to: (415-01 Information and Entertai

© 2011-2026 Copyright www.rrevoque.org