Range Rover Evoque: Evaporator Temperature Sensor

Removal

NOTE: Removal steps in this procedure may contain installation details.

1. Disconnect the battery ground cable.

Refer to: Specifications (414-01 Battery, Mounting and Cables, Specifications).

2. Refer to: Floor Console Upper Section (501-12 Instrument Panel and Console, Removal and Installation).

3.

Range Rover Evoque. Climate Control

4.

Range Rover Evoque. Climate Control

5.

Range Rover Evoque. Climate Control

6.

Range Rover Evoque. Climate Control

Installation

1. To install, reverse the removal procedure.

Heater Core TD4 2.2L Diesel

Removal

NOTE: Removal steps in this procedure may contain installation details.

1. Disconnect the battery ground cable.

Refer to: Specifications (414-01 Battery, Mounting and Cables, Specifications).

2. Refer to: Cooling System Partial Draining, Filling and Bleeding (303-03A Engine Cooling - TD4 2.2L Diesel, General Procedures).

3. Refer to: Electric Booster Heater (412-02 Auxiliary Climate Control, Removal and Installation).

4. CAUTION: Be prepared to collect escaping coolant.

Range Rover Evoque. Climate Control

5.

Range Rover Evoque. Climate Control

6. CAUTION: Be prepared to collect escaping coolant.

Range Rover Evoque. Climate Control

Installation

1. To install, reverse the removal procedure.

READ NEXT:

 Condenser TD4 2.2L Diesel

Removal CAUTION: Make sure that all openings are sealed. Use new blanking caps. NOTES: Removal steps in this procedure may contain installation details. Some variation in the illustrations may occur

 Heater Core and Evaporator Core Housing

Removal NOTE: Removal steps in this procedure may contain installation details. 1. Make the SRS system safe. Refer to: Standard Workshop Practices (100-00 General Information, Description and Operati

 Defrost Vent/Register Blend Door Actuator LHD AWD/LHD FWD

Removal NOTE: Removal steps in this procedure may contain installation details. 1. Disconnect the battery ground cable. Refer to: Specifications (414-01 Battery, Mounting and Cables, Specifications).

SEE MORE:

 Keyless entry

Keyless entry allows the vehicle to be opened if a Smart Key is within 1.0m (3ft) of the door handle or the tailgate external switch. The Smart Key may not be detected if it is placed within a metal container or if it is shielded by a device with a back-lit LCD screen, such as a smart phone,

 Rear Lower Arm AWD

Special Tool(s) 205-857 Remover, Halfshaft Removal CAUTION: LH illustration shown, RH is similar. NOTE: Some variation in the illustrations may occur, but the essential information is always correct. 1. WARNING: Make sure to support the vehicle with axle stands. Raise and support the vehicle. 2. Re

© 2011-2025 Copyright www.rrevoque.org