Range Rover Evoque: Isofix anchor points (not Australia)

restraints Do not attempt to fit ISOFIX restraints to the centre rear seating position.
The anchor bars are not designed to hold an ISOFIX restraint in this position.
If the restraint is not correctly anchored, there is a significant risk of injury to the child in the event of a collision or emergency braking.

Both of the outer seat positions on the rear seat are equipped to accept ISOFIX restraints.

This symbol is shown on a label

This symbol is shown on a label sewn into the seats to indicate the position of the ISOFIX lower anchorages.

READ NEXT:

 Isofix child seat positions

Isofix child seat positions - IUF = Suitable for ISOFIX forward child restraint systems of universal category approved for use in the mass group. - IL = These ISOFIX child restraint systems are

 Booster cushions

In a situation where a child is too large to fit into a child safety seat but is still too small to safely use just the three point belt, a booster seat is recommended for maximum safety. Follow t

 Installing an isofix child seat

Installing an isofix child seat To install an ISOFIX child seat: 1. Locate the ISOFIX locking mechanism. 2. Slide the child seat into the locking mechanism. 3. If an upper tether is fitted to t

SEE MORE:

 Front Door Trim Panel

Removal NOTE: Removal steps in this procedure may contain installation details. All vehicles 1. Torque: 6 Nm 2. Torque: 6 Nm 3. Torque: 0.9 Nm 4. Torque: 1.3 Nm 5-door 5. 3-door 6. All vehicles 7. 8. 9. NOTE: Do not disassemble further if the component is removed for access only. 10. 11.

 Electric Booster Heater - Description and Operation

Component Location COMPONENT LOCATION Heater assembly Electric booster heater Overview OVERVIEW Due to the slower warm up times associated with the diesel engine, an electric booster heater may be fitted to increase heater performance. The electric booster heater does this by heating the air

© 2011-2025 Copyright www.rrevoque.org