Range Rover Evoque: Lock confirmation
Land Rover Range Rover Evoque L538 (2011–2018) Owner's Manual / Exiting the vehicle / Lock confirmation
If you are uncertain whether the vehicle is locked and armed (either by single or double locking), press either the Smart Key lock button or, if Keyless entry is fitted, touch an exterior door handle lock sensor. The hazard warning lamps will flash once to indicate and confirm the current lock status.
Note: If the vehicle is not already locked and armed, pressing the lock button will single lock the vehicle. Press again to double lock, if required.
READ NEXT:
Single locking
Single locking secures the vehicle and prevents
the doors from being opened from outside. The
doors may still be unlocked and opened using
the interior door locks and release levers. In
this state
Double locking
Never double lock the vehicle
with
people, children, or pets inside. In the
event of an emergency they would be
unable to escape and the emergency
services would be unable to release
them quic
Mislock
When locking the vehicle with the Smart Key, if
one or more of the doors, the bonnet or the
tailgate is not fully closed, or the ignition is ON,
the vehicle will NOT lock and there will be an
audi
SEE MORE:
Condenser TD4 2.2L Diesel
Removal
CAUTION: Make sure that all openings are sealed. Use new blanking caps.
NOTES:
Removal steps in this procedure may contain installation details.
Some variation in the illustrations may occur, but the essential information is
always correct.
1. Disconnect the battery ground cable.
Refer t
Component Description
DESCRIPTION
Engine Control Module (ECM)
The ECM is located at the rear of the engine compartment, between the
bulkhead and the engine sound insulation. The ECM is located in a plastic molded
carrier which in turn is located in a bracket attached to the vehicle structure.
The ECM is connected to t
© 2011-2025 Copyright www.rrevoque.org
