Range Rover Evoque: Oil Filter Housing
Removal
NOTES:
Some illustrations may show the engine removed for clarity.
Some variation in the illustrations may occur, but the essential information is
always correct.
Removal steps in this procedure may contain installation details.
1. Refer to: Specifications (414-01 Battery, Mounting and Cables,
Specifications).
2. Refer to: Engine Cover - GTDi 2.0L Petrol (501-05 Interior Trim and
Ornamentation, Removal and Installation).
3. Refer to: Engine Oil Draining and Filling (303-01B Engine - GTDi 2.0L
Petrol, General Procedures).
4.
- Clamp the hoses to minimize coolant loss.

5. CAUTIONS:
Make sure that the area around the component is
clean and free of foreign material.
The O-ring seal is to be reused unless damaged.
READ NEXT:
Special Tool(s)
JLR-303-1595
Alignment Tool, Crankshaft Damper
Removal
NOTES:
Some illustrations may show the engine removed for clarity.
Some variation in the illustrations may occur, but the essent
Principles of Operation
For a detailed description of the engine system, refer to the relevant
Description and Operation section in the workshop
manual. REFER to: (303-01B Engine - GTDi 2.0L Petrol)
Special Tool(s)
303-1565
Locking Tool, Camshaft
308-511
Installer, Transmission Output Shaft Seal
JLR-303-1594
Locking Tool, Driveplate
JLR-303-748
Locking Tool, Crankshaft
Activation
1.
2. Install t
SEE MORE:
Component Location
COMPONENT LOCATION
High pressure line
Low pressure servicing connection
High pressure servicing connection
Thermostatic expansion valve
Evaporator
Refrigerant pressure sensor
Receiver/Drier
Condenser
A/C (air conditioning) compressor
Low pressure line
COMPONENT LOCATI
CAUTION: If
the front airbags are deployed, the following components must be replaced:
Driver airbag module
Steering wheel
Passenger airbag module
Instrument panel
Fly leads (where applicable) connecting front airbag modules to SRS
harness
All seat belt buckle pre-tensioner
All occupied
© 2011-2026 Copyright www.rrevoque.org
