Range Rover Evoque: Overhead Console
Removal
NOTE: Removal steps in this procedure may contain installation details.
1. CAUTION: Take extra care not to damage the edges of the component.
2.
3. NOTE: Do not disassemble further if the component is removed for access only.
4. CAUTION: Take extra care not to damage the wiring harnesses.
Take precautions to avoid any electrostatic charging, which could damage this comopnent.
5.
6. CAUTION: Take extra care not to damage the wiring harnesses.
7.
8.
Installation
1. CAUTION: Take extra care not to damage the wiring harnesses.
NOTE: If installing a new overhead console, make sure the original blanking plugs are installed to the new component.
To install, reverse the removal procedure.
Glove Compartment
Removal
NOTE: Removal steps in this procedure may contain installation details.
1.
2.
3.
4. NOTES:
Left-hand shown, right-hand similar.
The step must be carried out on both sides.
5.
6. Torque: 4 Nm
7.
8.
9. NOTE: Glove compartment shown removed for clarity.
10. Torque: 6 Nm
Installation
1. To install, reverse the removal procedure.
READ NEXT:
Floor Console Upper Section
Removal
NOTE: Removal steps in this procedure may contain installation details.
All vehicles
1. CAUTION: The procedure must be carried out on
both sides.
NOTE: LH illustration shown, RH is similar.
T
Locks, Latches and Entry Systems
Principle of Operation
For a detailed description of the locks, latches and entry systems and
operation, refer to the relevant Description and
Operation section of the workshop manual REFER to: Handl
SEE MORE:
Dab radio controls
Dab radio controls
See 104, TOUCH SCREEN OVERVIEW.
1. DAB Radio: Band selection. Touch to view
and select a DAB band (DAB 1, 2 or 3). The
radio will tune to the last used channel on
that band. Touch again to close.
The DAB band selection box will close
automatically after 5 seconds without
Daytime running lamps
Daytime running lamps are LED lamps.
With the lighting control in the OFF position or
in AUTO position while lighting conditions do
not require headlamps on, then daytime
running lamps will switch on automatically
under the following conditions:
- The engine is running.
- The gear selector is
