Range Rover Evoque manuals

Range Rover Evoque: Rear Quarter Window Glass 3-Door

Land Rover Range Rover Evoque L538 (2011–2018) Service Manual / Body and Paint / Glass, Frames and Mechanisms / Rear Quarter Window Glass 3-Door

Removal

1. Refer to: Rear Quarter Panel Moulding (501-08 Exterior Trim and Ornamentation, Removal and Installation).

2. Refer to: B-Pillar Upper Trim Panel - 3-Door (501-05 Interior Trim and Ornamentation, Removal and Installation).

3. Refer to: D-Pillar Trim Panel (501-05 Interior Trim and Ornamentation, Removal and Installation).

4. Refer to: Rear Quarter Trim Panel (501-05 Interior Trim and Ornamentation, Removal and Installation).

5.

Range Rover Evoque. Glass, Frames and Mechanisms

6.

Range Rover Evoque. Glass, Frames and Mechanisms

7. CAUTIONS:

Protect the surrounding components.

Protect the surrounding paintwork to avoid damage.

Pull glazing wire through windshield sealant to the inside of the vehicle.

Range Rover Evoque. Glass, Frames and Mechanisms

8. NOTE: This step requires the aid of another technician.

Range Rover Evoque. Glass, Frames and Mechanisms

Installation

1. CAUTIONS:

Make sure that the mating faces are clean and free of foreign material.

Correct preparation of body apertures 'post painting' to ensure satisfactory glass adhesion, must be carried out in line with industry practise.

Range Rover Evoque. Glass, Frames and Mechanisms

2. NOTE: Make sure that a Hi-modulus sealer (for example, Wurth Ultimate adhesive) is used when bonding the component to the vehicle.

Prepare the window glass, window glass flange and trimmed PU adhesive in accordance with the instructions included with the PU adhesive kit.

Range Rover Evoque. Glass, Frames and Mechanisms

3.

Range Rover Evoque. Glass, Frames and Mechanisms

4. Test the sealer for leaks, apply additional sealer if necessary. If water is used, allow sealer to dry before testing. Spray water around the glass and check for leaks. Mark any area that leaks. Dry the glass and sealer then apply additional sealer.

Range Rover Evoque. Glass, Frames and Mechanisms

5. To install, reverse the removal procedure.

READ NEXT:

 Liftgate Window Glass

Removal 1. Refer to: Rear Spoiler (501-08 Exterior Trim and Ornamentation, Removal and Installation). 2. 3. 4. CAUTION: The step must be carried out on both sides. 5. CAUTIONS: Protect the surroun

 Windshield Glass

Removal CAUTIONS: Always protect paintwork and glass when removing exterior components. Always protect the interior components when removing body glass. Lay the glass on felt covered supports. Do no

 Front Door Window Regulator and Motor

Removal NOTE: Removal steps in this procedure may contain installation details. 1. WARNING: To avoid accidental deployment, the restraints control module backup power supply must be depleted. Wait at

SEE MORE:

 Generator and Regulator - GTDi 2.0L Petrol

Generator - Component Location COMPONENT LOCATION Battery positive connection LIN (local interconnect network) bus connection Generator Generator - Overview OVERVIEW A single self-exciting generator is located at the front of the engine on the LH (left-hand) side of the cylinder block. There

 Shock Absorber and Spring Assembly Vehicles With: Dynamic Suspension

Special Tool(s) 205-754A Splitter, Ball Joints 205-857 Remover, Halfshaft JLR-204-804 Lever, Wheel Knuckle General Equipment Transmission jack Wooden Block Removal CAUTION: Nuts and bolts must be tightened with the weight of the vehicle on the suspension. NOTE: Some variation in the illustratio

© 2011-2025 Copyright www.rrevoque.org